TWM

Description

TWM identifies an entire sliding bearing family constituted from a complex fibre-winding technique. The highstrength backing consists of glass fibres and the sliding surface is made of PTFE and polymer fibres. Both layers are embedded in an epoxy resin matrix. This material selection combines the special mechanical properties of glass fibres with the outstanding tribological properties of PTFE and the high-strength polymer fibres.

Operating Conditions

Dry

Oil

Grease

Water

Process fluid

Very GoodGoodGoodFairFair

Availability

TWM benefits are for extreme operating conditions, most plain bearings need premature maintenance or replacement, TWM bushing are typically still operational.

  • Excellent sliding property;
  • High load carrying capacity;
  • Long service life;
  • Maintenance-free;
  • Insensitivity to edge loading and misalignment;
  • Good impact resistance;
  • Good noise and vibration damping;
  • Excellent resistance to corrosive media, even to salt water, and many chemicals;
  • Good insulator preventing passage of eletric current;
Maximum Specific Load Static230 N/mm2 (33350 psi)
Maximum Specific Load Dynamic125 N/mm2 (18130 psi)
Maximum PxV Factor1,05 N/mm2*m/s
Maximum PxV Factor short period1,50 N/mm2*m/s
Maximum Sliding Speed Dry0,10 m/s (20 fpm)
Break Straw350 N/mm2
Max Moisture Absorption (23°C)0,2% (ASTM D570)
Service Temperature Maximum+140°C (+284°F)
Service Temperature Minimum-100°C (-148°F)
Shaft Finish Ra (Advised)0,2&divide0,8 Ra μm
Shaft Hardness (Advised)>350 HB

The dimensions of TWM bushing correspond to ISO 4379 (1993). This provides full interchangeability with other bushings, e.g. bronze bushings. The tolerances after fitting into housing bore with H7 tolerance, will be within D11.

Base procedure for bushings mounting is to force them into their seats; there are same suggestion to follow:

  • Machine a 1 mm seat lead – in with an angle of 20° (±5°)
  • Check alignment between seat and bushing centre lines
  • Use a proper sized mandrel when possible.
  • Mounting can be done with hydraulic or mechanical tools.
  • We suggest to lubricate the internal surface just in start-up fazes.



Get Pricesheet and DWG files